P_BlurCelMulti
![]() |
![]() |
Before | After applying BlurCelMulti |
This effect adds a hierarchical blur process that expands colors.
For typical blurs, when the blur amount is increased, pixels in small areas are lost. BlurCelMulti expands the original pixel area while processing the blur.
Parameters Reference¶
View¶
Select how the effect is displayed.
Normal¶
Show the source image and the effect simultaneously.
Extract¶
Show only the areas where the effect is applied.
Base¶
Show only the areas where the effect of [Base] group is applied.
Process 1 - 4¶
Individually show the areas where the effects of [Process 1 - 4] are applied.
Base¶
Blur is processed by group. The blur processing for [Base] is different from the blur processing for [Process] groups. It is similar to the P_BlurCel processing and does not expand colors.
Blur Amount¶
Set the amount of blur.
Blur Repeat Num¶
Set the number of times the blur is re-applied to the image.
When using [Keep Division], patterns like streaks may appear. In such cases set this value to a large number.
Keep Division¶
Specify whether the blur effect will cross over main lines and other color areas.
![]() |
![]() |
ON | OFF |
Color 1 - 4¶
Set the colors to be used as the basis for processing.
Color Range 1 - 4¶
Set an extended range for the specified color.
Process 1 - 4¶
Blur is processed by group. The blur processing for [Process] groups is different from the blur processing for [Base] and expands colors.
With P_BlurCel, when a specified color is adjacent to multiple colors, it is not possible to blur that color for the multiple colors. With P_BlurMulti, it is possible to blur for multiple colors by expanding the specified color.
![]() |
![]() |
Original material | Using [Base] for red and blue, using [Process] for green |
Enable Process¶
Check this box to enable the corresponding Process group.
Color¶
Set the color to be used as the basis for processing.
Color Range¶
Set an extended range for the specified color.
Boundary Blur¶
Set the amount of blur.
Blur Repeat Num¶
Set the number of times the blur is re-applied to the image.
When using [Keep Division], patterns like streaks may appear. In such cases set this value to a large number.
Boundary Bias¶
Set the width of the blurring.
Keep Division¶
Specify whether the blur effect will cross over main lines and other color areas.