Skip to content

P_BlurCelLayer

BlurCel BlurCel
Before After applying BlurCelLayer

This effect applies blur by referencing the colors of a specified layer.

It can add blur to images that have already been blurred or had gradients applied to them.

Parameters Reference

View

Select how the effect is displayed.

Normal

Show the source image and the effect simultaneously.

Extract

Show only the areas where the effect is applied.

Group 1 - 4

Individually show the areas where the effects of [Group 1 - 4] are applied.

Color Group 1 - 4

Apply blur processing by group.

Enable Color Group

Check this box to enable the corresponding effect group.

Reference Layer

Specify the layer that [Color 1 - 8] will reference for blur processing.

Blur Type

Select the blur algorithm.

Gaussian

Apply a Gaussian blur.

Box

Apply a box blur.

Blur Amount

Set the amount of blur.

Blur Repeat Num

Set the number of times the blur is re-applied to the image.
When using [Keep Division], patterns like streaks may appear. In such cases set this value to a large number.

Keep Division

Specify whether the blur effect will cross over main lines and other color areas.

ON OFF

Enable 1 - 8

Specify the colors to which blur processing will be applied.

Color 1 - 8

Set the colors to be used as the basis for processing. The colors are referenced from the layer specified by [Reference Layer].

Color Range 1 - 8

Set an extended range for the specified color.

Example using the effect